Hinkley 99057F Serie Instrucciones De Instalación

A
B
Mounting
Bracket
Fig. 1
Hook-up
(5) Wires
Fan motor
assembly
Fig. 2
Safety cable clamp
Safety cable loop
Wood screw
and washer
Safety cable
Fig. 3
C
Outlet box
Screws
Motor coupler screws
Adaptor kit
Decorative ring
Wood ceiling joist
Hook
FLUSH MOUNT ADAPTER
INSTALLATION FOR IVER FAN
A)
Mounting Bracket
B)
Adaptor Kit
C)
Decorative ring
INSTALLING THE MOUNTING BRACKET
REMEMBER -Turn off the power !
Attach mounting bracket to outlet box using screws
provided with the outlet box. (Fig.1)
HANGING THE FAN
Step 1. Remove three of the six motor coupler screws
and lock washers (every other one) from the motor
coupler on top of the motor. (Fig.2)
Step 2. Feed the wires and safety cable from the fan
motor through the decorative ring and adaptor kit.
Step 3. Align the mounting holes in the bottom of the
adaptor kit with the holes in the motor coupler where
the screws were removed in step 1. Fasten using the
three motor coupler screws with lock washer previously
removed.
Step 4. Tighten the motor coupler screws securely.
Step 5. Carefully lift fan motor assembly (without the
blades) into position by hanging the motor assembly
onto the hook from the ceiling mounting bracket
allowing it to hang freely. (Fig.3)
Step 6. Attach the wood screw and the flat washer to
the ceiling joist as shown (do not fully tighten). Slide
the cable clamp onto the safety cable from the fan.
Loop the safety cable around the wood screw that
was just attached to ceiling joist. Feed the end of the
cable into the clamp and pull as much cable through
as possible. Firmly tighten screw in the clamp. Cut off
excess cable and firmly tighten the wood screw to
ceiling joist.
You are now ready to make the electrical connections.
Model: 99057FXX
PARTS