Hewlett Packard HP 9145A Guía De Referencia página 3

®
@
o
HP 9145A
Quick Reference Guide
Front Panel
1. Fault Light
When the Fault light is lit, there is a fault with the tape cartridge or
the drive.
If the fault is in the cartridge, the Fault light will go out when you
insert a different cartridge.
If the tape drive itself is faulty, the Fault light will remain lit when you
change the cartridge. In this case, contact your Hewlett-Packard
representative.
2. Protect Light
The Protect light is lit continuously when the cartridge in the tape
drive is write-protected, or is not the correct type for the HP 9145A. In
either case you can read data from the tape, but cannot write to the
tape.
The Protect light flashes when the cartridge is nearing the end of its
useful life. Copy the data onto a new tape and discard the old one.
3. Busy Light
The Busy light is lit when a tape is being loaded or unloaded and
when the tape drive is processing data.
4. Eject Button
Press the Eject button to remove an unloaded tape cartridge from
the tape drive.
5. Unload Button
Press the Unload button to unload the tape cartridge.
6. Loaded Light
The Loaded light indicates whether a tape cartridge is loading,
loaded or unloading.
When the Loaded light is flashing, the tape is either loading or being
unloaded.
When a cartridge is loaded, the Loaded light is lit continuously.
7. Clean Light
When the Clean light is lit, you should use the cleaning cartridge.