Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
LOADING FASTENERS
A fastener can be driven unintentionally if the trigger and safety
bracket are activated at the same time. Always disconnect tool
from air supply before loading fasteners, making adjustments, or
performing any service on tool. Keep finger off trigger until ready
to drive a fastener.
LOADING INSTRUCTIONS
1. Pull pusher (A) back to latched
position at rear of magazine.
2. Load staple strips (B) over
magazine track. Slide strips
down so that staple crowns ride
on top rail, then slide forward
toward tool nose.
3. Pull pusher (A) back and press
release lever (C) to release
latch. Slide pusher forward
against staple strips and
release. DO NOT allow pusher
to snap forward against staple.
4. Tool is now loaded and ready
to be connected to an air supply
for operation.
DANGER
10
Publicidad
