Realwear NAVIGATOR Z1 Manual Del Usuario página 3

3.2 NEC & CEC
The REALWEAR NAVIGATOR® Z1 model T21S is approved for use in Division 1 and 2 Class I, II,
III.
3.3 Manufacturer
i.safe MOBILE GmbH
i_Park Tauberfranken 10
97922 Lauda-Koenigshofen Germany
4. Faults and Damage
Before entering ex-hazardous areas, the safety of the device must be checked. If there is any reason
to suspect that the safety of the device has been compromised, it must be withdrawn from use and
removed from any ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the device. The safety of the device
may be compromised, if, for example:
•
Malfunctions occur.
•
The housing of the device shows damage.
•
The device has been exposed to excessive loads.
•
The device has been stored improperly.
•
Markings or labels on the device are illegible.
•
Permitted limit values have been exceeded.
It is recommended that a device displaying errors or for which an error is suspected be sent back to
an authorized service center to be checked.
5. Ex-relevant / Intrinsic Safety Regulations
Use of this device assumes that the operator observes the conventional safety regulations and has
read and understood the user manual, safety instructions and safety certificate. The following
additional safety regulations must be complied with:
5.1 Charging and battery
•
The device may only be charged outside ex-hazardous areas using the i.safe
PROTECTOR 2.0 USB-C Cable (or other equipment approved by i.safe MOBILE GmbH.)
•
Spare battery packs may only be charged outside ex-hazardous areas using the i.safe
PROTECTOR 2.0 USB-C Cable and i.safe MOBILE GmbH approved charging equipment
(e.g., charging cradles).
•
Battery removal and installation may only be done outside the ex-hazardous areas.
•
Individual (uninstalled) batteries may not be taken into the ex-hazardous areas.
•
Ensure proper installation of the battery before entry into ex-hazardous areas. The battery
must be properly mounted and screwed down with all screw covers in place.
•
The device may only be charged at temperatures between +5°C and +40°C.
5.2 Connections and covers
• Physical connections to other equipment are only permitted outside ex-hazardous areas,
using the i.safe PROTECTOR 2.0 USB-C Cable (or other equipment approved by i.safe
MOBILE GmbH.)
• Inside ex-hazardous areas, the covers of the USB connector must be kept closed.
• The audio jack can be used to connect approved headsets inside ex-hazardous areas.
02-00102501-007-000
REV02