Publicidad
Idiomas disponibles
Idiomas disponibles
Common problems and solution
Problems
Blank Screen
Pressure Head doesn't
move
Rollers don't move
Keeping Running and
Unstoppable
Cans cannot comple-
tely sealed or leak.
Cans out of shape or
don't move
Reasons & ways of Solution
1.Check the electricity, make sure the power is on.
2.Power line loosen,check and plug well.
3.Circuit board breaks down may also cause this
problem.Change a new circuit board.
The line of big electrical machinery may be loose
and pls open the back cover to check and recon-
nect if the black/red line is loosen.
2.If the electrical machinery is out of work, it need
to be replaced with a new one.
1. The line of small electrical machinery may be
loose and pls open the back cover to check and
reconnect if the black/red/white line is loosen.
2.If the small electrical machinery is out of work,it
need to be replaced with a new one.
1. The lines connected to Start button may be
loosen or not connected.Open the back cover to
check the two lines (1red and 1 black) and recon-
nect if the line is loosen.
2.The screws of the button may be loosen, tighten
it.
3. The operating button is broken down and need
to be changed.
Adjusting rod position may be too low.Adjust it to
right place.
The bearing of bottom support may be dropped.
Publicidad
