GE AEW14 Serie Manual Del Propietario Y Instrucciones De Instalación página 7

I stall ti
I structi
ns
Air Conditio r
BEFOREYOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT - Save these i nstructions
for local inspector's use.
• IMPORTANT - Observe all
g overning
codes and ordinances.
• Note to Installer- Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these instructions for
future reference.
,, Skill level- Installation of this appliance
requires basic mechanical skills.
,, Completion time - Approximately 1 hour
,, We recommend that two people install
this product.
,, Proper installation is the responsibility
of the installer.
,, Product failure due to improper installation is not
covered under the Warranty.
,, You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
ELECTRICAL REQUIREMENTS
Some models require a 115/120-volt AC,
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall outlet
you plan to use is only a 2-prong outlet, it is your
responsibility to have it replaced with a properly
grounded 3-prong wall outlet.
©
@
Some models require 230/208-volt AC,
protected with a time-delay fuse or circuit
breaker. These models should be installed on
their own single branch circuit for best
performance and to prevent overloading
house or apartment wiring circuits, which
could cause a possible fire hazard from
overheating wires.
ACAUTION:
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
Do not change the plug on the power cord
of this air conditioner.
Aluminum house wiring may present special
problems--consult a qualified electrician.
TOOLSYOU WILL NEED
Phillips head screwdriver
Pencil
Flat-blade screwdriver
Ruler or tape measure
Level Scissors or knife
Power cord includes a current interrupter device. A
test and reset button is provided on the plug case. The
device should be tested on a periodic basis by first
pressing the TEST button and then the RESETbutton
while plugged into the outlet. If the TEST button does
not trip or if the RESETbutton will not stay engaged,
discontinue use of the air conditioner and contact a
qualified service technician.