ERRECOM Jet Gun Pro Manual De Uso página 7

ATTENTION
Dry running of the device will damage the pump. If pressure does not build up in the device after 1 minute, switch the
device off and proceed according to the instructions in chapter "Troubleshooting".
Press the ON/OFF button to start the device.
1.
1
Note:
Green light ON: Full Battery
Green light flashing: Half battery
Press the lever of the trigger gun.
2.
Release the lever of the trigger gun to stop the water jet.
3.
Press the ON/OFF button to stop the device.
4.
Interrupting operation
• Release the lever of the trigger gun.
Ending operation
1. Turn off the device.
OPERATION
Red light ON: Low battery
Red light flashing: Empty Battery
2. Remove the reservoir. 3. Switch the device on. 4. Actuate the lever of the
trigger gun until no more
water is emitted.
7
EN