Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
1.
Please make sure to turn off the power before starting the installation.
2. Installation must be performed by a qualified electrician.
3. For indoor use only.
DESCRIPTION
The product is a small controller with a capacitive sensor. It has two operating functions: on/off and dimming
(adjusting the brightness of LED lighting) within wide ranges (10%-100%).
ON / OFF FUNCTION
By a single quick hand touch on the surface above the mounted sensor, the LED is turned on. By a second quick
hand touch on the same place, the LED lighting is turned off.
DIMMING (ADJUSTING BRIGHTNESS)
By a long hand-touch on the surface above the mounted sensor, the brightness of the LED lighting is increased
or decreased. By second long hand-touch, the brightness is adjusted at the opposite direction.
Note: The dimming switch is intended exclusively for LED lighting. After a power loss and its restoration, the
switch remains in the off position.
INSTALLATION INSTRUCTIONS
Inside of the door
Dimmer
Controller
1.
Clean the inside of the door thoroughly and install the controller here.(FIG 1)
2. Peel off the protective film from the adhesive sticker. (FIG 2)
3. Stick the dimming switch on the mounting surface(FIG 1)
4. Connect the OUTPUT connector to the load and the INPUT connector to the power
supply for te LED lights.
NOTE
•
Must be installed on the reverse side of the mounting surface.
•
Surface thickness ≤ 25mm.
•
Not suitable for installation behind mirrors or metal surfaces as it would not function.
Thickness: Max 25mm
Touch Location
FIG 1
Outside of the door
FIG 2
Publicidad
