Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING PUMP AND FAN
NOTE: Ensure tank is full before turning on.
NOTE: Ensure caster brakes are engaged.
CLEANING
The removable panel and pads can be gently sprayed
off to remove build-up. A soft bristle brush may also be
used.
NOTE: Never spray pads with water while cooler
is in operation. This may damage motor and
void warranty.
NOTE: Vinegar is recommended for cleaning
and can be periodically cycled through during
normal use.
BACK PANEL REMOVAL
1. Disconnect unit from power supply. Remove two
Phillips screws from upper back side of cooler.
(See Figure 5)
2. Pull panel down and pull bottom out to remove.
(See Figure 5)
Figure 5
PAGE 3 OF 12
OPERATION
1. Turn pump switch to "ON" position. Water will begin to
flow down to media pads.
2. Turn fan switch to desired speed.
MAINTENANCE
REMOVAL OF RIGID MEDIA
Once back panel is removed, media pads will be
accessible.
NOTE: Some pads may be held in place with
pins. Remove to free pads.
STORAGE
Ensure pads are dry by running fan without pump for at
least 30 minutes.
IMPORTANT! Always drain tanks and wipe dry
before storing.
0124 IH-11188
Publicidad
