Publicidad
Idiomas disponibles
Idiomas disponibles
7.1
Assembly of the shredder
▪
Turn the shredder upside down.
▪
Insert the wheel axle (10) through the pre-drilled holes in the foot (Fig. 1).
▪
Select the support A and B which are identified by the letter stamped on the actual
support.
▪
Insert the foot (11) into the body.
▪
Mount the wheel in the same order illustrated in fig 2 ensure the nut is not too tight.
▪
Tighten the hand screw (2). The hand screw has a safety switch please ensure the knob is
tightened or the motor will not activate.
NOTE: It is dangerous to use the machine without the hopper (1).
8
OPERATION
8.1
On/off switch (Fig. 3)
▪
Press the on/off switch to start and/or stop the machine.
Note: the machine is equipped with a safety switch to prevent it from being switched on again
accidentally after a power failure.
8.2
Overload protection (Fig. 4)
Overload (e.g. blocking up of the cutting blades) leads to a standstill of the machine after a few
seconds. To protect the motor from being damaged, the overload switch (8) will cut the mains
automatically. Wait at least 1 minute before restarting by first pressing the reset button and
then the on/off switch.
In the event of blocking of the cutting blade, turn the rotational direction switch to the right
position before switching the shredder on again
If the motor does not restart, do the following:
▪
Remove the plug from the mains socket.
▪
Loosen the hand screw (2) and open the top part upwards.
▪
Clean carefully the cutting and discharge parts and remove any objects that could obstruct
the blades.
▪
Put the top part back and tighten the hand screw firmly.
▪
Press the reset button before pressing the On/Off switch.
Attention! Always wear safety gloves when executing the steps mentioned
above!
8.3
Safety lock
The shredder is equipped with the safety switch at the lock between the top and bottom parts.
If the top part does not fit perfectly and sit fast on the bottom part, the SAFETY SWITCH is
activated and the motor will not work. If this happens:
▪
Remove the plug from the mains socket.
▪
Remove the top part, as described in the previous paragraph.
▪
Clean carefully the cutting and discharge parts and remove any objects that could obstruct
the blades.
▪
Put them together again and tighten the hand screw firmly.
▪
Zet terug in elkaar en draai de handschroef stevig aan.
ATTENTION: Never loosen the hand screw before first turning off the On/Off
switch and removing the plug from the mains socket.
Copyright © 2022 VARO
POWEG5011
P a g i n a
| 9
EN
www.varo.com
Publicidad
