Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly and Installation (continued)
Installing the post light on the post when the wire
3
beside the post
Use a pliers to clamp off the (1) part of the adaptor (C/D) so that the male
□
plug (B) can pass through the (1) part.
Insert the male plug (B) into the female plug (F) beside the post.
□
Place the adaptor (C/D) over the top of the post, use a pencil (sold
□
separately) to gently mark the location of the two holes on the wall.
Remove the adaptor (C/D) from the post. Use a drill to bore two 5 mm
□
deep holes in the wall, placing the holes following the location of the two
holes on the adaptor (C/D).
Insert the plastic anchors (BB) into the holes on the wall, screw the self-
□
threading screws (AA) into the plastic anchors (BB) to fix the adaptor (C/D)
on the post.
4
Connecting the wires and applying caulk
WARNING: The wire connector (E) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION: The wire from the low voltage power unit should be
12-16 AWG type underground low Energy Circuit Cable.
IMPORTANT:
Protect the wiring by routing it in close proximity to the light
□
fitting, or next to a building structure such as a house or a
deck.
The landscape wire and connector can also be hidden under
□
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
Place the wire connector (E) on opposite sides of the low voltage
□
cable (sold separately) from the transformer (sold separately)
where the fixture will be located.
Align and fit the main low voltage cable vertically to the slot of the
□
wire connector (E).
Press the wire connector (E) together until it is locked around the
□
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
Once the wire connector (E) is in place, it is recommended to wrap
□
it with electrical tape (sold separately).
After all fixtures are installed, turn on the transformer.
□
Caulk the space between the post and the full area of the adaptor
□
(C/D) to prevent water seeping into the outlet box.
2
Publicidad
