Publicidad
Idiomas disponibles
Idiomas disponibles
5. Install the top large panel by inserting the slide lock tabs of all four small panels into the
receiving channels and slide until the panel is snug.
6. Flip the Eco-Blox on its side and push down where the large and small panels meet until
all edges are aligned.
7. To complete the assembly, rotate the Eco-Blox so that the bottom panel is flat on the
ground and the top panel is facing up. In this position, the top panel is supported by the
sides as well as the center support panels. EcoBlox must always be installed in this
position. Improper installation will reduce the structural integrity of the unit and may
cause the Eco-Blox to fail.
Building Multiple Eco-Blox Modules
Start with an assembled Eco-Blox. The top panel
replaces the bottom panel from Step 1.
Begin by installing the 4 small panels from Step 2
onto the finished Eco-Blox and continue through
Step 7. Repeat for taller Eco-Blox modules.
Installation
Eco-Blox water matrix reservoirs are a strong,
versatile way to store water underground,
but a few guidelines must be followed for
proper performance and longevity.
EcoBlox must be oriented with the top panel
covering the edges of all vertical panels. Setting
the Eco-Blox on its end or side, with exposed edges on top, will allow the panels to
decouple under load and potentially, collapse.
CORRECT
ORIENTATION
INCORRECT
ORIENTATION
3
Publicidad
