Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
4. When finished, shut off the pressure washer. Relieve any pressure left in the line by pulling trigger on spray
gun. Remove the foam cannon from the quick connect fitting.
5. Remove the sprayer from the bottle. Turn sprayer "counterclockwise" until you can remove it from the bottle.
6. Empty any remaining soap mixture.
CARE AND MAINTENANCE
1. Clean the foam cannon with fresh water after each use.
To clean foam cannon, take the sprayer (without the
bottle) and hook it back up to spray gun or wand. Place
intake tube into a bucket of clean water. Turn on
pressure washer and run clean water through the
sprayer.
2. When done, turn off pressure washer, disconnect
sprayer and dry.
Filter Replacement
Over time, the foam cannon filter can become clogged with built-up debris. Cleaning or replacing the filter will
resolve this issue.
1. Remove locking pin from cone assembly.
2. Remove black cone, cone knob, baffle, seal ring and adapter.
3. Remove filter with flat head screwdriver.
4. Wash filter with soap and hot water. If filter is still dirty, replace.
5. Insert filter and reassemble cone assembly.
TROUBLESHOOTING
PROBLEM
Connections leak.
Low soap output.
WARRANTY
TWO YEARS LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for two (2) years from
date of purchase. If within this period a product is found to be defective in material or workmanship, the
product must be returned with a copy of the bill of sale as proof of purchase to the manufacturer. This warranty
does not cover the product becoming defective due to misuse, accidental damage, improper handing and/or
installation and specifically excludes liability for direct, incidental or consequential damages. As some states do
not allow exclusions or limitations on how long an implied warranty lasts, the above exclusions and limitations
may not apply to you. This warranty gives you specific rights and you may also have other rights which vary
from state to state. For warranty service, call +1 (866) 870-9930, 9 a.m. - 5 p.m., EST, Monday - Friday.
POSSIBLE CAUSE
1. Inlet plug loose.
2. Bad coupler.
1. Too little soap added.
2. Filter is clogged.
1
CORRECTIVE ACTION
1. Retighten fittings.
2. Replace coupler.
1. Check soap manufacturer's dilution
recommendation.
2. Try cleaning the filter.
3. Replace the filter.
2
Printed in China
www.surfacemaxx.com
Publicidad
