Publicidad
Idiomas disponibles
Idiomas disponibles
MUFFLER
Inspect and replace corroded muffler as it
could create a fire hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning of
each mowing season or after every 100
hours of operation, whichever occurs
first. Spark plug type and gap setting
are shown in the "PRODUCT
SPECIFIC-
ATIONS" section of this manual.
CLEANING
IMPORTANT:
For best performance,
keep
mower housing free of built-up grass and
trash. Clean the underside of your mower
after each use.
_CAUTION:
Disconnect spark plug wire
from spark plug and place wire where it
cannot come into contact with plug.
• Clean the underside of your lawn mower
by scraping to remove build-up of grass
and trash.
• Clean engine often to keep trash from
accumulating.
A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• We do not recommend using a garden
hose to clean lawn mower unless the
electrical system, muffler, air filter and
carburetor are covered to keep water
out. Water in engine can result in short-
ened engine life.
CLEAN UNDER DRIVE COVER
Clean under drive cover at least twice a
season. Scrape underside of cover with
putty knife or similar tool to remove any
build-up of trash or grass on underside of
drive cover.
ACLWARNING:
To avoid serious
injury,
before
performing
any service
and
adjustments:
1.
Release
control
bar and stop engine.
2.
Make sure the blade and all moving
parts have completely
stopped.
3.
Disconnect
spark plug wire from spark
plug and place wire where
it cannot
come into contact
with plug.
TO REPLACE
DRIVE
BELT
1.
Install
new belt on engine
pulley.
2.
Reinstall
debris
shield
and blade.
3.
Return
mower to upright
position.
4.
Install
new belt on gearcase
pulley.
5.
Reinstall
drive cover.
NOTE:
Always
use factory
approved
belt
to assure
fit and long life.
LAWN
MOWER
TO ADJUST
CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual.
REAR
DEFLECTOR
The rear deflector,
attached
between the rear
wheels of your mower, is provided to minimize
the possibility
that objects
will be thrown
out
of the rear of the mower
into the operator
mowing
position.
If the deflector
becomes
damaged,
it should
be replaced.
TO REMOVE DRIVE BELT
1. Remove drive cover. Remove belt from
gearcase pulley by pushing down on
pulley and rolling belt off it.
2. Turn lawn mower on its side with air
filter and carburetor up.
3. Remove blade.
4. Remove debris shield.
5. Remove belt from engine pulley on
crankshaft.
Drive
cover
Belt
PUSH DOWN
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and wire tie(s)
securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
13
Publicidad
