Publicidad
Idiomas disponibles
Idiomas disponibles
Charging and Discharging the capacitor
The capacitor must be charged before the first use. Connect the GND of the capacitor to
the vehicle battery's negative (-) terminal, then connect the +12V of the capacitor to the
vehicle battery's positive (+) terminal with the supplied resistor (Fig. 1), to prevent possible
damage to the capacitor. When the voltage is between 10 to 12, you can disconnect the
resistor. To discharge the capacitor, connect the GND to the +12V of the capacitor with the
supplied resistor (Fig. 2). As it goes off, the capacitor is discharged and can be disconnected.
Fig. 1
To Battery Ground
To Battery +12V
Fig. 2
Control LCD
The HB CB20F top panel has a display that indicates the current voltage.
Control LCD
Technical Specifications
Capacity:
20 Farad
Working Voltage:
12V DC
Peak Voltage:
16V DC
Resistance (E.S.R.):
0.0015 Ohm @ 120Hz/25°C
Dimensions (mm):
115 (W) x 45.5 (H) x 160-184(L)
Publicidad
