Monkey loop ML-BST1 Manual De Usuario página 2

MONKEY LOOP
AC/DC Adapter Jack
Use only specified AC
adapter, and connect it to
an AC outlet of the correct
voltage.
Low Knob
Adjust the low
frequency under
250Hz of the input
signal. If the Low
knob points at the
center, there is no
change in the
frequency. Turn
clockwise to
maximum position,
there will be+14dB m
low frequency boost
for signal under
250Hz. Turn
anti-clockwise to
minimum position,
there will be-14dB low
frequency lost for
signal under 250Hz.
Output Jack
Connect this jack to
your amp or to the
input of another effect
pedal.
ML-BST1
ML-BST1
Pedal Switch
This switch turns the
effect ON/OFF.
High Knob
Adjust the high
frequency above 1K Hz
of the input signal. If the
High knob points at the
center, there is no
change in the
frequency. Turn
clockwise to maximum
position,there will be
+14dB high frequency
boost for signal above
1K Hz. Turn
anti-clockwise to
minimum position, there
will be- 14dB high
frequency cut for signal
above 1K Hz.
Input Jack
This jack accepts
signals from a
guitar or other effect
pedals.
Level Knob
Adjusts the level of the
output.
Indicator
The indicator shows
whether the effect is ON
or OFF.