Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not use the machine on a paved area that
has been graveled where discharged material
may cause injuries.
•
Ensure that the loading funnel inlet is empty
before you start the machine.
•
Keep your head and body away from the
infeed opening.
•
Do not move your hands, other body parts
or clothing into the infeed chamber, ejector
chute or near other moving parts.
•
Make sure that you are balanced and
standing on a firm surface at all times. Do not
stretch forward. Never stand higher than the
machine when feeding material into it.
•
Keep away from the discharge zone when
you start the machine.
•
If foreign bodies get into the cutting tool or
the machine generates unusual noises or
vibrates in a strange way, switch off the motor
immediately and allow the machine to come
to a standstill. Pull out the batteries and carry
out the following work:
- Check the machine for signs of damage.
- Check that all the parts are secure and
tighten them if necessary.
- Have any damaged parts replaced or
repaired, but use only spare parts of the
same type and equivalent quality.
•
If the machine is blocked, switch off the motor
and pull out the batteries before you start the
cleaning procedure. Ensure that the motor
is clear of waste and other accumulations to
protect the motor from suffering damage or
possibly catching fire.
•
Ensure that all the covers and guards are in
position and in good working order.
•
Do not tip the machine whilst the motor is
running.
•
Switch off the machine before you fit or
remove the collection bag.
•
The tool may only be used outdoors (i.e. not
in the vicinity of a wall or any other ridged
object).
•
Damaged or illegible labels must be replaced.
•
Allow the tool to cool before carrying out any
maintenance work, adjustments, etc.
•
Never use the machine while other people
are nearby.
•
When inserting material take special care
to ensure that it does not contain any metal,
stones, bottles, cans or other foreign bodies.
•
Do not allow processed material to
accumulate within the discharge area; this
could prevent the machine being able to
discharge correctly and result in material
Anl_Redaxxo_36_25_SPK7_NA.indb 10
Anl_Redaxxo_36_25_SPK7_NA.indb 10
EN
recoiling through the infeed opening.
•
When servicing the cutting tool, remember
that it may still be moving due to the starting
mechanism, even if the motor is not running
because of the cover interlock.
•
Wear ear protectors and safety goggles. Wear
these throughout the time the machine is in
operation.
•
Before starting the machine, check all screws,
nuts, bolts and other fastening materials
to ensure that they are secure and that all
covers and guards are in position. Damaged
or illegible labels must be replaced.
SAVE THESE INSTRUCTIONS
2. Layout and items supplied
2.1 Layout
1
Loading funnel inlet
2
Loading funnel
3
Battery cover
4
Wheels
5
Left chassis
6
Right chassis
7
Rear axle
8
Front axle
9
Wheel caps
10 Paddle
11 Transport handle
12 Release knob
13 On/Off switch
14 Motor housing
15 Ejector housing with cutter plate
16 Collection bag
17 Washers chassis (2x)
18 Screws chassis (2x)
19 Hex. key
20 Fastening screws (4x)
21 Washers (4x)
22 Sleeve (4x)
23 Clips
24 Screwdriver (not included)
25 Paddle holder
26 Blade
27 Blade screws
28 Holder for collection bag
29 Hex. key holder
30 Pushlock button
31 Battery capacity indicator
32 Battery capacity indicator button
- 10 -
20.11.2023 09:59:17
20.11.2023 09:59:17
Publicidad
