Waeco mobitronic RV-24 Instrucciones De Montaje Y De Servicio página 34

_RV-24_RV-27.book Seite 34 Dienstag, 18. Mai 2004 11:25 11
Mounting the camera
➤ Screw the camera bracket on with the M4 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable
(see e, page 6)
If possible, use available openings – such as ventilation grilles –
to feed the connection cables through. If there are no existing
openings, you must drill a hole with a 13 mm diameter.
Check beforehand that there is sufficient room for the drill
head to come out on the other side.
➤ Drill a hole of Ø 13 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Attaching the camera and camera guard
➤ Push the camera into the camera bracket (8 2, page 5).
Only use the screws supplied to mount the camera in the camera
bracket. Longer screws will damage the camera.
➤ Secure the camera loosely with the two screws M3 x 6 mm in the middle
threaded drill holes (see f, page 6).
The camera is now centred.
➤ Align the camera so that the lens is at an angle of approx. 50° to the
perpendicular axis of the vehicle (see g, page 7).
Never mount the camera without the additional camera guard.
To mount the camera guard, only use the supplied M3 x 8 mm
screws. Longer screws will damage the camera.
34
RV-24, RV-27