Pool Technologie Dosipool Ampero Instrucciones De Uso página 22

2. ELECTRONICS UNIT
2.1. First commissioning
BEFORE FIRST START-UP, carefully read the manual provided with the amperometric probe. This manual
contains instructions that are essential for successful start-up and optimal operation of the equipment. It is
imperative that you follow and strictly comply with all of this manual.
The first time you power up the electronics unit, carry out the programming below.
Successive
menus
Languages
FRANCAIS
From 10 to 160 m
Volume 50 m3
increments of 10 m
Recommended
None (read-only display)
Dose 40mL/h
From 10 to 990 mL/h, in
Dose setting
40mL/h increments of 10 mL/h
Day/Month/Year
Date 01/01/2023*
Hour/Minute
Time XX:XX
Software Version
None (read-only display)
XX.XX.XX
year of release of the application version
*
2.2. Keypad
COMMAND KEY
(depending on
the model)
Switching on the electronics unit.
Putting the electronics unit into standby (press and hold).
Menu
Access the menus.
Temporary cancellation of a pH injection.
Launch of a manual chlorine injection.
Boost
Selecting a value or data item.
Cancel a command.
Back to previous menu.
Switching off the manual injection.
Temporary cancellation of an alarm or alert
Command confirmation.
OK Enter a menu.
Cancelling an alarm.
Possible settings
Français
English
Deutsch
Español
Italiano
Nederlander
Portugués
3
3
A few minutes after switching on, chlorine dosing and pH regulation start automatically,
provided that these functions are not disabled, and certain alarms have not been activated
The device cannot be put on standby from a menu
I
, in
For each menu, select a setting with the
confirm with the OK button.
FUNCTION
Navigation
.
buttons, then
.
4