Peavey MARK VI BASS XP Serie Manual Del Usuario página 3

seine susana
{0}
Foner O
HIGH GAIN INPUT (1)
Used for most electric basses. It is 6 dB louder than the Low Gain Input.
LOW GAIN INPUT (2)
Provided for instruments that have extremely high outputs, which can result in overdriving (distorting) the
High Gain input. If both inputs are used simultaneously, the output levels are the same (both are Low Gain).
PRE GAIN (3)
Controls the input gain of the preamplifier.
BRIGHT SWITCH (4)
Provides a preset boost (+8 dB) to treble frequencies. To activate, depress the switch to its "in" position.
PUNCH SWITCH (5)
Provides a preset boost (+8 dB) to midbass frequencies. To activate, depress the switch to its "in" position
POST GAIN (6)
Controls the overall volume level of the amplifier. The final level adjustment should be made after the desired
sound has been achieved.
LEVEL (7)
Adjusts the output level of the compressor/limiter.
COMPRESSOR ACTIVE SWITCH AND DISPLAY (8)
To activate the compressor, depress the switch to the "in" position. The LED will light when the compressor
is active.
COMP/LIM (9)
Adjusts the amount of compression (compression ratio).
LOW (10)
An active tone control (shelving type, +15 dB) that varies the low frequency range.
CAUTION: Excessive low frequency boost causes greater power consumption and increases possibility of
speaker damage.
GRAPHIC EQ (11)
Provides +15 dB equalization at each center frequency.
HIGH (12)
An active tone control (shelving type, +15 dB) that varies tne high freguency range.