Publicidad
Idiomas disponibles
Idiomas disponibles
SPEAKER CONNECTION
Before connecting the speakers, disconnect the AC power cord. Please note the proper
connection terminals as shown below. Make sure the total impedance is not less than
the stated nominal impedance.
- Connection of speaker systems from 4 to 16 Ω
When connecting conventional 4 to 16 Ω speaker systems, connect the positive (+) side
of the speaker to the terminal labeled 4 to 16 Ω. Connect the negative (-) side of the
speaker to the terminal labeled COM (pin 2)
- Connecting high impedance distributed speaker systems
When connecting a high impedance (100V) speaker system in parallel, connect the
positive (+) side of the speaker to the terminal labeled 100V (pin 3). Connect the
negative (-) side of the speaker to the terminal labeled - (pin 1)
FOR 100V SPEAKER WITH
TRANSFORMER CONNECTION
www.audibax.com
FOR 8 ohms LOW IMPEDANCE SPEAKER
CONNECTION
PA2250T / PA2500T
8Ω
WRONG SPEAKER CONNECTION
6
Publicidad
