Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Frost forms on
the walls of the
freezer.
The water
dispenser is not
functioning.
The auto close
system does
not work with
the freezer
door.
Condensation
or water
drops forms
on vertical
mullion and
surroundings,
etc.
DA68-02952B-07.indb 36
SOLUTION
• Is the air vent blocked?
Remove any obstructions so air can circulate freely.
• Allow sufficient space between the stored foods for efficient air circulation.
• Is the freezer drawer closed properly?
If the freezer drawer is not completely closed or is blocked, humidity from outside may
enter and cause severe frost to form.
• Is the water line connected and the shut-off valve opened?
• Has the water supply line tubing been crushed or kinked?
• Make sure the tubing is free and clear of any obstruction.
• Is the water tank frozen because the fridge temperature is too low?
Try selecting a warmer setting on the Digital display.
• Is the Child Lock on?
• Check if the filter is properly installed.
If it is not properly installed, the water dispenser may not work.
• Is there an imbalance between the right and left parts of the door?
• Open and close the door smoothly 1~2 times.
After you do this, the auto close system usually works properly again.
• Try opening the door smoothly to avoid unbalancing the right and the left part of the
door.
• Condensation or water drops may form if the humidity is too high while the refrigerator
is operating.
• If condensation or water drops appears on vertical mullion and surroundings, etc., turn
the Energy Saver mode off after removing the condensation.
(See the explanation of the Energy Saver button in "Using the Control Panel" on page
18
.)
English - 36
2018. 7. 9.
4:54
Publicidad
