N8WERK C011 Manual De Operación página 13

SAFETY DEVICES
The device has two safety switches (8,
11). The UV-C lamp (13) only switches on
if both safety switches are pressed into
the motor unit (4) (automatic switch-off
function of the UV-C lamp deactivated).
This happens automatically when the
device is placed on a flat surface. If the
safety switches lose contact with the
surface below, the automatic switch-off
function is activated and the UV-C lamp
stops being lit.
TIPS AND HINTS
○ Always clean mattresses on both
sides.
○ We recommend cleaning new mat-
tresses once a month. Older mattress-
es should initially be cleaned every
day for a week. We then recommend
cleaning them once a month.
○ The filters should be replaced every
12 – 18 months; the UV-C lamp (13)
should be replaced every 12 – 24
months. If you have any questions
about spare parts, please contact the
customer service department via our
website: n8werk.com
12
USE
Please Note!
■ The device should only be used if it
has been correctly assembled! The
dust container and EPA filter must be
inserted and must not be damaged! If
dirt were to get inside the motor unit,
this could damage the motor.
■ Make sure that the safety switches of
the UV-C lamp are not blocked!
■ Always test the device first on a small,
inconspicuous spot.
1. Fully unwind the connecting cable.
2. Connect to a plug socket that is prop-
erly installed. The mains voltage must
match the technical data of the device.
The plug socket must be readily ac-
cessible so that the connection to the
mains can quickly be isolated.
3. Place the device down flat on the sur-
face which is to be cleaned.
4. Press the On / Off switch (2) to switch
on the device. The device starts to vac-
uum and the UV-C lamp (13) switches
on.
L
You can look through the viewing
window (5) to check whether the
UV-C lamp is switched on.
The vibrating plate (7) shakes up
the surface which is to be cleaned
and the dust which is agitated
is sucked in through the suction
opening (10).
5. Guide the device over the surface to be
cleaned.
6. After vacuuming, press the On / Off
switch to switch off the device.
7. Pull the mains plug out of the plug
socket.