Publicidad
Idiomas disponibles
Idiomas disponibles
Always use the device on a stable, dry surface and out of the reach of children
and persons with reduced mental, sensory and intellectual functions. When
charging the battery, the device should be positioned in such a way that the
mains plug can be reached at any time. Make sure that the energy supply of the
device corresponds to the data given on the rating plate!
ASSEMBLING THE APPLIANCE
The appliance is supplied ready for use, however, before the first start-up it is
recommended that the appliance is connected to a charger for possible
recharging. To do this, first connect the cable with the plug to the corresponding
cable with socket from the charger, and then connect the cable with the plug
from the charger to the socket on the control panel of the unit. The display on
the control panel shows the current battery voltage (fully charged >14V).
IMPORTANT: the unit can only be charged when switched off (ignition key in the
"OFF" position) and with the cover closed.
3.3.
Device use
a)
Unfold the control handle and adjust its height according to the operator's
preference.
b)
Ensure that the dirt container is empty and the air filter is fitted.
c)
(c) [Optional] Pour water into the container if using dust spray).
d)
Adjust the height of the brushes.
e)
Start the machine by setting the ignition key to the "ON" or (optional)
"ON+water mist spray" position.
IMPORTANT: do not use the water spray function when the water tank is
empty!
f)
Switch on the appropriate brush sets.
g)
You can start working with the device...
TIPS FOR OPERATING THE MACHINE:
Make sure that the machine's battery is charged before each use. Even if
•
you use the machine infrequently or do not use it for a long period,
connect the machine to the charger once in a while (e.g. once a month).
Maintain an even moving speed during operation - ideally not exceeding
•
5 km/h.
Clean the air filter every 30-40 min. work, using the lever.
•
Empty the dirt container regularly, as well as every time you finish
•
working with the machine.
If the thickness of the dirt exceeds 2 mm, it may be necessary to drive
•
over the surface several times to clean it more thoroughly.
EN
Publicidad
