heatwell SMART STEEL Manual De Instrucciones página 8

2. SETTING UP
2.1 STARTING THE DEVICE
First, plug in the power cord to a mains power outlet, and click the switch on the right. Press
turns on.
2.2 CONFIGURATION OF SETTING TEMPERATURE
Once the unit is ON, press
see images below.
2.3 SELECT THE OPERATING MODE
There are 4 operating modes:

Manual. The user determines the setpoint temperature.

Timer: The user selects both the setpoint temperature and the operating time or downtime.

Replay. The user selects desired temperature and time duration- the unit automatically starts and stops.

Fil pilot.
Manual Mode
To select temperature, press
Timer Mode
Timer connection: The device will work at the preset temperature as per user's configuration
Press to select the desired temperature
Press  to select the operating time. By pressing  repeatedly, operating hours or a combination of operating hours will be
selected. E.g.
To deactivate the timer function press  repeatedly until the time LEDs are deactivated.
Timer disconnection. The device will stop working as per user's configuration.
On starting the device again, press
Press during 2 seconds to switch to OFF mode.
Press  to select the switch-off time of the device. Press and hold  repeatedly to select the operating hours or the combination of
operating hours of the device.
E.g.
To deactivate the timer function press
to select the desired temperature. Depending on the temperature selected, light displayed is different;
18 ºC
22 ºC
repeatedly until the light activates on the desired temperature (see figures 2.2).
The unit is programmed at 21ºC during 5 hours.
to select the temperature to reach.
The device is disconnected during 5 hours
repeatedly
to turn on the radiator, ECO light
19 ºC
24 ºC
21 ºC