USA
Safety
− Only use the shaver with the enclosed po-
wer supply unit. The shaver requires safety
extra-low voltage (SELV) with the values
specified in the chapter "Technical data".
− Only connect the power supply unit to an
easily accessible socket so that you can
quickly disconnect it from the grid in case
of a failure.
− If the power cord, the power supply unit
or the shaver exhibit visible damages or
are defective, do not use them further.
− If the power cord of the shaver is da-
maged, the manufacturer, its customer
service team or a person with similar
qualifications must replace it.
− Never operate the shaver when it has
a damaged cord or plug, when it is not
working properly, after it has been drop-
ped or damaged, or after it has been
dropped into water. Return the shaver
to a service center for examination and
repair.
− Do not use outdoors or operate where
aerosol (spray) products are being used
or where oxygen is being administered.
12
TM3service@outlook.com
877-386-8264
USA