120/240 single Phase, 60 Amp Double Pole
Capacity Relays (handles loads 15 to 60 Amps)
Coverage for the RSH-VRM Voltage Range Monitoring Device and the 60AMP Disconnect Breaker
3-Year Limited Product Warranty
PSP Products, Inc. ("Manufacturer") warrants this product to be free from defects in material or workmanship for a period of three (3) years
following the date of purchase.
The warranty does not cover defects or malfunction caused by misuse, abuse or improper maintenance, failure to follow operating instruc-
tions, improper installation or application, acts of God, or normal wear and tear. Also, the warranty will not apply to damage caused by
unauthorized alteration, modification, or repair of the product.
Manufacturer shall not be liable for any costs of removal or installation. Manufacturer's sole and exclusive obligation under this warranty
shall be limited to repair or replacement of the defective item.
This limited warranty gives you specific legal rights, and you also may have other rights that vary from state to state or country to country. The
laws of certain jurisdictions do not allow limitations on impliedwarranties or the exclusion or limitation of certain damages, so some or all
the above disclaimers, exclusions or limitations may not apply or apply fully to you.
Coverage for the RSH-50 Surge Protective Device (SPD) for Single-Phase System
Lifetime Product Warranty
PSP Products, Inc. ("Manufacturer") will, at its sole discretion, repair or replace any RSH-50 Surge Protection Device (SPD) that is defective
or is damaged by an electrical surge (including those caused by lightning) for the lifetime of the product from the date of installation by the
original owner or owner of record of the premises (User) at no cost to the User.
Connected Equipment Warranty
Manufacturer will, at its sole discretion, repair or replace heating, ventilation and air conditioning equipment that is damaged as a result of
SPD failure during a surge event. Coverage is applicable only if the SPD (1) was fully functional immediately prior to the claim event; (2) was
properly installed per the installation instructions; and (3) sustained surge damage as a result of the claim event.
Damage claims must be made within 14 days of the occurrence and the SPD returned to Manufacturer within 30 days of the occurrence
with the original purchase receipts of the SPD. Returned SPDs require an RMA (Return Materials Authorization) number and a completed
Warranty Claim Form (contact Warranty Assistance for details), and the SPD must be determined to have failed based on Manufacturer's test
procedures.
This coverage is secondary to any applicable warranties, service contracts and all other insurance. If the claim is found to be valid, Manufac-
turer will pay up to the deductible amount of the homeowner's insurance or the cost of the damage, whichever is less, subject to a $5000.00
limit per occurrence. All the above items must be met in order to have a valid claim.
The above coverage applies to the User only and is the exclusive remedy under this warranty, whether based on contract, tort, including
negligence, or otherwise. Manufacturer reserves the right to audit the damages, site and/or cost of repairs and may require a notarized proof
of loss. This warranty does not cover damage associated with sustained over voltages, vandalism, theft, normal wear and tear, obsolescence,
abuse, unauthorized modification or alteration, misuse, improper installation or catastrophic events including direct lightning hit.
Except as expressly provided by this warranty, Manufacturer disclaims liability for any incidental, indirect, special or consequential damages
arising out of the sale or use of SPDs (including without limitation: lost business profits, loss of data and all freight, mileage, travel time and
insurance charges associated with warranty coverage claims). Some states do not allow the exclusion or limitation of incidental or conse-
quential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may have
other rights which vary from state to state. This warranty is valid in the United States and Canada only.
Caution: Effective surge suppression requires correct wiring and all SPDs must be properly grounded for this warranty to be honored.
For Warranty Assistance call 866-280-8810 • PO Box 4108, Manassas, VA 20110
Voltage or current hazard, follow these instructions or
it could result in serious bodily injury or death.
Most electric product-related incidents are caused by failure to observe basic safely rules or
precautions. Rectorseal cannot anticipate every possible circumstance that might involve a
potential hazard.
Requirement
Installation MUST be completed by a qualified licensed tradesman
in the field of electrical installation. This would include a thorough
understanding of the requirements of NFPA 70: National Electrical
Code® and all local codes.
W A R R A N T Y I N F O R M A T I O N
& S A F E T Y N O T I C E
Installation Process
The Installation must conform to these instructions and the local
code authority having jurisdiction and the requirements of the
power company. In the absence of code requirements follow NFPA
70 (latest edition) National Electric Code.
The Code which may be ordered from: National Fire Protection
Association, 1 Batterymarch Park, Quincy, MA 02269.
Electric Shock Hazard!