Publicidad
ENG
1. Mode button ("Mode")
2. Reset button ("Reset")
3. Up button ("Up")
4. LCD display
Warning instructions
Additional warnings are included in the other included manual (2 manuals included total).
1. Do not plug two or more energy meters together.
2. For indoor use only.
3. Do not place the energy meter so that it is difficult to disconnect it from the power
outlet. It must be easily accessible.
4. Don't connect an appliance with loads exceeding 16 Ampere. Ensure that the appliance's
plug is fully inserted into the outlet.
5. When you clean this device, disconnect first from the mains power and wipe off with
a dry cloth.
Use
1. Connect the wall plug to a power outlet, and then connect a device to this wall plug.
Energy monitoring starts automatically.
The display defaults to showing Volt.
2. To switch between Watt and Volt, press the mode button.
3. Press the up button to switch display between total kWh > total cost "€" > cost per
kWh (€ kWh).
The display shows this symbol: €, it is the euro symbol, but here it symbolizes cost. So
set according to your local currency(optional), and it will be correct. To set to your local
currency, just do the below, set the cost per kWh.
Optional: set the cost per kWh. Press the up button until it displays € kWh. Press and hold
the mode button for about 3 seconds until it flashes.
4. Press the up button to set numbers (00.00).
5. Press the mode button to save the number.
6. Repeat step 1 and 2 for each number.
7. Press the mode button to finish. The display confirms by showing "V".
If no user action is detected within 10 seconds, it will cancel the setting.
This device saves the data internally and remembers it even if it is disconnected from
power.
To reset, press the reset button with something thin.
Display values
These are the min and max values possible for the display.
kWh = 0.0 to 9999
Set cost "€ kWh" = 00.00 to 99.99
Total cost "€" = 00.00 to 9999
Watt = 0.3 to 3680
Volt = 150.0 to 276.0
Troubleshooting
In case the display behaving strange, or the buttons are not responding. Try to reset.
Publicidad
