Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
• Install in a clean, dry, and safe environment.
• Please identify all parts and hardware pieces before you begin. When laying out
parts, place them on a soft surface to prevent scratching. Assemble on the floor. If
any pieces are missing, please contact your retailer.
2. HOW TO USE
PARTS (see "Content")
A. Tube Assembly
B. Tube
C. Shelf
• Measure the distance between the corner of the tub ledge or the corner of the show-
er stall floor to the ceiling to the nearest half inch. See the diagram 1 to determine
the tubes that are needed.
NOTE: To adjust the shelf brackets, lift the lever up to slide up or down.
• Pull the smaller tube of the tube assembly (A) so the entire assembly measures 2
inches longer. If necessary, untighten the rod by turning the larger tube counterclock-
wise and the smaller tube clockwise, then adjust the length (Fig. 3-1).
• Lock the assembly (A) by twisting the smaller tube in the direction of the arrow (Fig.
3-2).
• Place the top of the unit against the ceiling in the desired location. Compress the unit
up and move the bottom end into place so that the unit is in a vertical position (Fig.
3-3). Make sure the assembly is in place, vertical, and secure.
• Attach the shelves (C) onto the shelf brackets (Fig. 4-1). Adjust the shelves by lifting
the lever and moving the shelf brackets up or down (Fig. 4-2).
Troubleshooting
• If the assembly does not have enough tension, make sure that the assembly mea-
sures 2 inches longer.
• If shelves slide down when weight is added, make sure that the shelf bracket lever
is pressed down into the locked position.
Publicidad
