Mx Onda MX-CPV2037C Manual De Instrucciones página 22

Type of water to use
This ironing center has been designed to work with normal tap water. The use
of waters with chemical contents such as softeners, starches, water softeners,
etc. they can leave residues or stains on clothes during the vaporization
process, especially at high temperatures. It is also not advisable to use distilled
water for batteries, or from thawing, condensation, etc.
Filling the water tank
1. Lift the handle by pressing the retention buttons 10 (UNLOCK).
2. Remove the anti-lime filter 3 by pulling it upwards (Fig. 7).
3. Fill the water tank with the dosing cup without exceeding the "MAX" mark.
4. Replace the anti-lime filter 3 in the hole of the water tank (Fig.9).
5. During ironing you can fill the water tank as many times as necessary
without having to wait for the ironing center to cool down, so follow steps 1
to 4 above.
Fig. 7
Refilling the water tank
When the water level in tank 1 reaches a low level or is completely drained, the
main unit will begin to produce a noise, because air is entering instead of
water. DO NOT continue ironing with steam and fill the water tank as described
in the previous section.
IRONING GUIDE
To prevent damage to the garment you want to iron, read the following ironing
board carefully. Check the clothing label first and then choose the
corresponding temperature. Before ironing directly on the garment try first
inside the hem of the same.
Fig. 8
7
Fig. 9