Cobb PREMIER GAS PGA001 Manual De Instrucciones página 6

When using gas canisters
When using gas canisters – Model PGA001
Model PGA001 Use Butane canister which complies with EN417 specifications for Europe
fitting the gas canister into the Premier Gas Cobb (model PGa001)
• Always fit the gas canister away from an open flame or source of ignition
• The gas canister is to be fitted outdoors to avoid harm
• Ensure the rubber seal (on the canister) is in good working condition as well as seated properly (see operating
instruction on gas canister by the manufacturer) Regulator knob must be in "off" position
• If holding the canister vertically, tilt it slightly towards the regulator, place into regulator and screw on tightly in a
clockwise direction to a hand tight position only.
• If you detect a smell of gas, ensure the regulator knob is in the off position. Unscrew the gas canister, turning the
canister to the left (anti clockwise) prior to reconnecting. Be certain the canister threads are not cross threaded and
ensure that seal is correctly seated. Do not use an open flame to check for leaks
• By using soapy water (50% water - 50% liquid soap solution) you can check for leaks by applying the soapy water to joints.
If there is a formation of bubbles, then there is a leak. If it still leaks after refitting the canister, please return the appliance to
your local dealer for attention. Once the canister is empty remove by unscrewing to the left (anti-clockwise)
• Do not incinerate or puncture the canister even if empty.
Igniting your Gas Cobb
• Prior to igniting your Gas Cobb, ensure the canister is fitted correctly and you are in an area free of flammable liquid
or vapour
• The Gas Cobb must be placed in a secure, level and stable position. Remove the dome and the Grill Grid to expose the burner
• Depress and turn the control knob in an anti-clockwise direction and then press the igniter button. If the flame does
not ignite first time, repeat until the spark ignites the gas.
• Once ignited the flame can be adjusted by turning the control knob between low and high to the necessary
requirements.
• Place the Grill Grid onto the inner sleeve and allow the Grill Grid to warm up for 3 minutes with the dome in place.
6
All manuals and user guides at all-guides.com