Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of the original instructions
OPERATING INSTRUCTIONS
TECHNICAL DATA
Light Source
Luminous Power
Operating time
Battery Specification
Charging Time
Charging Input
Degree of protection
Operating temperature
WARNING
• Do not open the device.
• Do not look directly into the light emitting lamp - Risk of eye injuries!
• Do not operate in direct sun light or extreme temperature conditions.
• Operating temperature, -10°C to +40°C.
• Keep away from children! Children should be supervised in order to ensure that they do not play with the device!
OPERATING & CHARGING PROCEDURE
• PRO INSPECTION LAMP - Operating mode :
- Press the button once, the top LED lights up (120 Lm).
- Press the button a 2nd time, the main LED lights up at medium power (150 Lm).
- Press the button a 3rd time, the main LED switches to full power (800 Lm).
- Press the button a 4th time, the LED on the back lights up at medium power (120 Lm).
- Press the button a 5th time, the LED on the back switches to full power (400 Lm).
- Finally, press the button a 6th time to turn the lamp off.
• When a mode is used for more than 5 seconds, pressing the button turns the lamp off. Press the button again to
switch the lamp back to the last used mode.
• Connect the lamp with the supplied USB charging cable to recharge it.
• The 3 green LEDs indicate the charge status. If they are all off, then the lamp is completely discharged.
• When charging, the flashing LED indicates how far the battery is recharged.
• The charge is complete when all green LEDs are solid.
• If the charging indicator does not light up, disconnect and then reconnect USB cable.
• Always use the USB cable recommended for this lamp.
• Using a non-recommended cable can cause a fire and destroy the lamp
• Charge the lamp for 4-5 hours before first use.
• Charge the lamp to 100% before storing it for a long time.
SAFETY INSTRUCTIONS
• Do not use the device if there is damage to the housing, plug or cable. Consult your local authorized specialist!
• Do not open the device! Repair work and replacing the rechargeable battery pack may only be carried out by electricians.
• Carry out cleaning tasks only when the mains plug is removed from the mains power!
• There is a risk of short-circuit. Repairs on the device may only be carried out by commissioned and trained persons.
Please contact your nearest authorized branch.
• Protect the battery against heat, e. g., against continuous intense sunlight, fire, water, and moisture. Danger of
explosion.
4
INSPECTION LAMP PRO 800L
Keep this instruction manual for future reference or for subsequent possessors.
High power COB LED
ca. 120 lumen - Top LED
ca. 150/800 lumen - Main LED
ca. 120/400 lumen - Back LED
ca. 8 h - Top LED
ca. 8/2,5 h - Main LED
(min/max)
ca. 9/4 h - Back LED
(min/max)
Li-Ion 3.7 V, 2600 mAh, 9.62 Wh
ca. 4 h
DC 5V 1A
IP 54 , IK 07
-10 °C to +40 °C
(min/max)
(min/max)
EN
Publicidad
