Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
1. Remove the power supply from its packaging.
2. Use the provided screws to install the power supply
into your computer case. NOTE: It is recommended
to install the power supply with the fan facing down.
However, if your case places the power supply at the
bottom of the case and there are no ventilation holes
there, it may be best to install the power supply with the
fan facing up for greater efficiency and reliability.
3. Connect the 24-pin ATX cable to the motherboard.
NOTE: This power supply allows you to detach the four
right-most pins to make this connector into a 20-pin
connector. Under NO circumstances should you plug the
extra four-pin connector into your motherboard' s 4-pin
ATX12V or "P4" connector.Serious damage may occur.
4. Connect the 8-pin EPS12V cable(s) to the
motherboard.
One of the EPS12V connectors can be split to form a
4-pin ATX12V connector if your board lacks an EPS12V
connector.
5. Connect the 6/8-pin PCIe cables or PCIe 5.0
depending to your graphics card(s).
NOTE: Do not attempt to plug an 8-pin PCIe cable into
a 6-pin connector without first detaching the two extra
pins.
6. Connect the SATA cables to your system' s drives (hard
drives, solid state drives, and optical drives). If your
motherboard supports additional PCIe power delivery
via SATA connector, connect a SATA cable to your
motherboard as well.
7. Connect the peripheral "molex" connectors to the power supply and your fans,
Publicidad
