Publicidad
Idiomas disponibles
Idiomas disponibles
Power supply
♦
Use a 1.5 V battery
To insert the supplied battery
3) Push the housing
firmly in place and the gap is fully closed. The anti-slip
dimples on the housing
the anti-slip dimples on the hand set
the housing
ing button
NOTE
►
If the effectiveness of the cleaning starts to decrease, the
battery
Handling and use
This section provides important information about proper hand-
ling and operation of the appliance.
Fitting the cleaning attachment
1) Remove the appliance head
that the dot on the appliance head
head
2) Push the attachment fitting
cleaning attachments
feel a slight click.
3) Pull the hand set
cleaning attachment
4) Check that the cleaning attachment
to the attachment fitting
attachment
more force.
NZR 1.5 B1
1) Carefully pull the housing
and place it to one side.
2) Insert the battery
markings given in the battery compartment.
must be on the same side as the operat-
.
needs to be replaced.
symbol on the hand set
upwards and off.
onto the attachment fitting
to operate the appliance.
proceed as follows:
. Pay attention to the polarity
back onto the hand set
must be on the same side as
by turning it slightly so
. Then pull the appliance
into the hole of one of the
in the storage box
away from the storage box
comes out of the storage box
. If necessary, push the cleaning
off the hand set
until it sits
. The writing on
is aligned with the
. You will
. The
is firmly attached
with slightly
GB │ IE
│
21
.
■
Publicidad
