Electric Connection - Infinity MDR Instrucciones De Montaje

EN
1. Warnings
Please read carefully the instructions given below,
as they supply you with all the needed information,
necessary for installation, use and maintenance.
- Once you receive the pump check out for the
pump integrity and all of its components, in
case of any anomalies, please consult a skilled
staff before making any operation.
- This manual has to be preserved with care in
order to be consulted as needed.
- Before installing the pump make sure that the
electrical data reported on the pumps' label
correspond to those of your electrical plant.
- Do not operate on the pump with wet hands
or feet
- Do not leave the equipment exposed to the
action of atmospheric agents.
- The equipment has to be operated by skilled
persons.
- In case of an improper functioning of the pump
switch off and contact our technical assistance
for any reparation request.
- For a correct functioning it is necessary to use
original spare parts and original INFINITY
accessories. Declines whatever responsibility
in reference to break down due to tampering
or the use of not original spare parts and
accessories.
- The electrical plant has to be in conformity with
the rules of the country where it is realised.
The usage room temperature can't over take 40° C.
The minimum temperature depends on the chemical
that must remain in the liquid state.
Design standard
Our pumps are built accordingly to the current gene-
ral standards endowed with CE mark in conformity
with the following European directives:
- n° 89/336/CEE regarding "electromagnetic
compatibi lities"
- n° 73/23/CEE regarding "low voltages", as
also the subsequent modification N°93/68/CEE
Granted this we think that in order to obtain an high
trustworthiness and a lasting functioning of the pump
it is necessary to follow with attention our manual
particularly in reference to the maintenance.
INFINITY declines all responsibility in reference
to any intervention on the equipment from a non
skilled staff.
14
2. Standard supplied accessories
1. 2m PE delivery hose 4x6
2. n°2 nipples ½"
3. n°2 screws for fixing to wall with anchors
3. Installation
3.1 Wall fixing
Use the 2 screws provided to hang the panel on the
wall. 315mm is the distance between the holes in
the wall.

3.2 Electric connection

Connect the plug schuko (A) to the electrical pow-
er supply. Before installation ensure that the supply
is adequately earthed and is fitted with a suitably
sensitive circuit breaker (RCD). Connect the panel
to the power supply respecting the values you can
see on the identify label of the panel and verify the
display is lit. To avoid damages caused by the other
equipments (TRANSFER pumps) do not connect ever
the panel directly but use a teleruptor. Your pumps
have 2 internal electrical protection devices, a fuse
and an integrated overvoltage protection on circuit
board. (VDR)