Descargar Imprimir esta página

Craftsman 917.389621 Manual Del Propietário página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

• Open
MulcherDoor
BEFORE STARTING
ENGINE
ADD OIL
Your lawnmower is shipped without oil in
the engine. Engine holds 20 oz. of oil.
For type and grade of oil to use, see
_ENGINE" in Maintenance section of this
manual.
1. Be sure lawnmower is level and area
around oil fill is clean.
2. Remove engine oil cop and fill to the
full line on the dipstick. Pour oil slowly•
Do not over fill.
NOTE: Allow oil to settle down into engine
for accurate reading. To read proper level,
tighten engine oil cop, then remove it to
read the dipstick.
3. Reinstall engine oil cop and tighten.
• Check oil level before each use. Add
oil if needed. Fill to full line on dipstick•
• Change the oil after every 25 hours of
operation or each season. You may
need to change the oil more often
under dusty, dirty conditions.
ADD GASOLINE
• Fill fuel tank. Use fresh, clean, regular
unleaded gasoline with a minimum of
87 octane. Do not mix oil with gaso-
line. Purchase fuel in quantities that
con be used within 30 days to assure
fuel freshness.
AWARNING:
Experience indicotesthat
alcohol blended fuels (called gasohol or
using ethanol or methanol) con attract
moisture which leads to separation and
formation of acids during storage• Acidic
gas con damage the fuel system of an
engine while in storage. To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or
longer. Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season. See Storage Instructionsfor
additional information. Never use engine
or carburetor cleaner products in the fuel
tank or permanent damage may occur.
_, CAUTION: Fill to bottom of gas tank
filler neck. Do not overfill. Wipe off any
spilled oil or fuel. Do not store, spill or
use gasoline near an open flame.
Engine _Y=I_
Gasoline fiUer
cap____
cap
TO START ENGINE
NOTE: Due to prote_ve coatings on the
engine, a small amount of smoke may be
present during the initial usa of the
product and should be considered
normal.
1. To start a cold engine, push primer
three (3) times before trying to start.
Use a firm push. This step is not
usually necessary when starting an
engine which has already run for a
few minutes.
2. Hold operator presence control bar
down to the handle and pull starter
handle quickly. Do not allow starter
rope to snap back.
TO STOP ENGINE
• To stop engine, release operator
presence control bar.
NOTE: In cooler weather it may be
necessary to repeat priming steps. In
warmer weather over priming may cause
flooding and engine will not start. If you
do flood engine, wait a few minutes
before attempting to start and do not
repeat priming steps.

Publicidad

loading