Publicidad
Idiomas disponibles
Idiomas disponibles
installation
STEP 1
Using a stud finder (available at low cost at most hardwa-
re stores) or other accurate method, locate center point
between two joists and mark. Using template provided, trace
hole pattern on surface of ceiling.
STEP 2
Using a sabre saw, keyhole saw or very sharp utility knife,
cut hole in ceiling. Following trace pattern.
STEP 3
Run loudspeaker wire to sound source location.There are
serveral methods you can use to accomplish wiring, depen-
ding on the construction characteristics of the room or hou-
se.You can add a professional touch to your installation by
using a speaker terminal plate at the source location. Leave
sufficient amount of wire at speaker location (8-10 inches /
20-25 cm) to complete connection.
STEP 4
Attach loud speaker wires to speaker terminals, observing
correct polarity and position speaker frame up into cutout.
Be careful not pinch wires in the process.
STEP 5
Carefully tighten the four mounting screws. This will cause
the mounting wings to rotate our behind the mounting surfa-
ce and secure the speaker in place.
- 8 -
User Manual
Publicidad
