Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
1
Attaching the leg to the table top
Place the table top (A) upside down so the pre-drilled corner
holes are visible.
Align and attach the table legs (B and C) to the corners of table top
(A), using at washers (AA), spring washers (BB) and hex nuts
(CC).
Loosely tighten the nuts with the wrench (DD).
B
C
IMPORTANT:
Each of the four leg bolts should be
attached and initially tightened only a few revolutions.
Then tighten further, one at a time, alternating between
the four legs. Do NOT fully tighten one leg before you
attach the other legs.
AA
C
BB
CC
DD
B
A
2
Tightening the nuts
Tighten all the nuts one by one to ensure all legs
are rmly secured to the table top.
3
The table is ready for use
With assistance, carefully turn the table to the upright
position. Adjust the balance of the legs with the leveler
under the legs.
Your table is ready for use now.
4
Please contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM
Publicidad
