Publicidad
Idiomas disponibles
Idiomas disponibles
This product comes equipped with a polarized electrical plug (one blade is
wider than the other) and will only fit into the outlet one way. This is meant
to reduce the risk of an electrical shock. If the plug does not fit into the outlet,
reverse the plug. If it still does not fit, consult a qualified electrician. DO NOT
ATTEMPT TO MODIFY THIS PLUG OR CIRCUMVENT THIS SAFETY FEATURE.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment Generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modification to this device could void the user's authority to operate the equipment.
IMPORTANT: DO NOT REMOVE OR ATTEMPT TO REMOVE THE
FABRIC COVER FROM THIS DEVICE, SERIOUS BURNS OR
Please read all warnings and caution statements within this manual before using.
1. Connect the power cord to the receptacle on the heating pad by matching
up the arrows on the both the power cord and receptacle. The plug on the
power cord will only fit into the receptacle one way.
2. Insert the plug into an appropriate 120 volt AC electrical outlet, noting the
plug is polarized and will only fit one way.
3. Place the heating pad on shoulders. The tall collar should sit
on the back of the neck while the two front edges connect
with plastic snap to help keep the wrap in place. NOTE:
Neck wrap should comfortably fit around the neck and
NEVER restrict the airway.
WARNING: THE PAD SHOULD ALWAYS BE PLACE ON TOP OF THE TREATMENT AREA. DO
NOT PLACE PAD UNDERNEATH TREATMENT AREA AS TEMPERATURES CAN RISE TO
UNINTENDED/UNCOMFORTABLE LEVELS.
4. Using the controller, slide the button to reach the desired heat setting (Lo, Med, Hi). To
turn the heating pad off, slide the button to the 'Off' position.
5. Pay close attention to the heat level during use and adjust the setting as needed.
6. The heating pad will reach the desired temperature in approximately 10~20 minutes.
NOTE: This heating pad will automatically turn OFF after 2 hours of use. Unplug heating pad
when not in use.
POLARIZED PLUG
FCC STATEMENT AND
EMC COMPATIBILITY
INSTRUCTIONS FOR USE
INJURY COULD RESULT
FOR DRY HEAT APPLICATIONS ONLY
3
Publicidad
