Publicidad
Technical data
Description
Net Weight
Engine
Engine Rated Power
Fuel Tank
Cutting Capacity
Shaft length
Cutting Systems
Blade diameter
Nylon thread diameter
Handle shape
Duty Cycle
Fuel Specifications
• The gas brushcutter runs with an air-cooled two-cycle engine and uses a mix of unleaded gasoline and high quality,
self-mixing motor oil with fuel stabilizer specified for air-cooled -2 stroke motor.
• The motor is certified to run with unleaded gasoline for vehicles having an octane index of 87 ([R+M]/2) or higher.
• Do not use any type of gasoline and oil mix sold in Service stations, especially, used in motorcycles.
• Do not use motor oil for self-propulsion, or two-cycle oil outboard motor.
• The ratio for the mix shall be 40 parts gasoline per 1 part oil (40:1 Ratio). Prepare the mix in an approved fuel container.
Always mix thoroughly before pouring it into the motor fuel tank.
CAUTION
Do not use a fuel mix that has been sored longer than 15 days. Mix small quantities.
Never smoke near the fuel or where fuel is being supplied, or in the oil-gasoline mix preparing site or
WARNING
when operating the brush trimmer.
WARNING
Trying to start the gas brushcutter without mixing oil into the fuel will cause a faulty motor.
Use
1
L
1 liter
Gasoline
To extend the motor's useful life use
Code
Speed
ACT-2T-4 or ACT-2T-16 oil caps** to measure the mix.
Mix 5 capfuls oil per each gasoline liter.
A wrong mix may cause the gas brushcutter to throw a rod
causing expensive repairs!
+
5 capfuls oil
* 1 gallon = 3.78 liters
DES-52P
26104
Gas brushcutter
16.3 lb
52 cm
(cc)
3
1400 W
20 oz
9300 RPM
17"
54"
Nylon thread spool and blade
Outer: 10"
Inner: 1"
From 0.080" to 0.155" (advisable)
Offset handle
40 minutes rest per consumed tank.
Daily maximum: 5 hours.
=
synthetic oil for 2-stroke motors.
** Not included
ratio
40:1
Mix
ENGLISH
3
Publicidad
