Epcom EPP-SPB12H150 Manual De Usuario página 10

7. Comandos ASCII
El producto también admite control de comandos ASCII. Conecte el puerto RS-232 del producto a una PC con un cable
conector Phoenix de 3 pines. Luego, abra una herramienta de comando serie en la PC para enviar comandos ASCII para
controlar el producto. La lista de comandos ASCII sobre el producto se muestra a continuación.
Serial port protocol. Baud rate: 115200 (default), Data bits: 8bit, Stop bits:1, Check bit: 0
x - Parameter 1
y - Parameter 2
! - Delimiter
Command Code
Power on/off the
s power z! device,z=0~1 (z=0 power off,
z=1 power on)
r power! Get current power state
s reboot! Reboot the device
help! List all commands
r type! Get device model
r status! Get device current status
r fw version! Get Firmware version
Get the connection status of
r link in!
the input port
Get the connection status of
the y output port, y=0~3
r link out y!
(0=all, 1~2=HDBT 1~2, 3 =
loop out)
s reset! Reset to factory defaults
ASCII Commands
Function Description Example
Power
Power on
System Initializing...
s power 1!
Initialization Finished! FW
version x.xx.xx
r power! power on/power off
Reboot...
System Initializing...
s reboot!
Initialization Finished! FW
version x.xx.xx
System Setup
help!
r type! HDC-SPB12H150
Get the unit all status: power,
r status!
in/out connection, edid mode
MCU BOOT: Vx.xx.xx MCU
r fw version!
APP: Vx.xx.xx
r link in! HDMI IN: connect
hdmi loop out: connect
r link out 1!
hdbt output 1: connect
Reset to factory defaults
System Initializing...
s reset!
Initialization Finished! FW
version x.xx.xx
Feedback Default Setting
power on
10