Página 2
ENGLISH General Guidelines 1. Please read the following instruction carefully and use the product accordingly. 2. Please keep this manual and hand it over when you transfer the product. 3. This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed.
Página 3
DEUTSCH Einleitung 1. Bitte lesen Sie die folgende Anleitung aufmerksam durch und verwenden Sie das Produkt sachgemäß. 2. Bewahren Sie diese Anleitung gut auf und händigen Sie sie bei Weitergabe des Produkts an Dritte ebenfalls mit aus. 3. Aus Gründen der Übersicht können nicht alle Details zu allen Varianten und denkbaren Montagen beschrieben werden.
Página 5
ITALIANO Linee Guida Generali 1. Si prega di leggere attentamente le seguenti istruzioni e usare il prodotto in modo opportuno. 2. Si prega di conservare questo manuale e consegnarlo quando il prodotto cambia proprietario. 3. Questo riassunto potrebbe non includere ogni dettaglio di tutte le variazioni e le fasi considerate.
Página 6
ESPAÑOL Acerca del manual 1. Por favor, lea detenidamente las instrucciones y respete los debidos usos del producto. 2. Por favor, conserve bien este manual y en caso de cesión, no omita entregarlo junto al producto. 3. Este manual podría no incluir todos los detalles de cada paso del montaje. Si necesita ayuda o información adicional, póngase en contacto con nosotros.
Página 7
PARTS LIST [x1] [x1] [x1] [x1] [x1] [x1] [x1] [x1] [x1] [x1]...
Página 8
HARDWARE LIST [x1] [x4] [x12] [x21] [x1]...
Página 9
ATTENTION -The door can only be opened on the outer right side. Please finish the assembly as shown to ensure that the door lock can be used normally.
Página 10
ATTENTION -During assembly, first loosely align all screws with the corresponding pre-drilled holes and then tighten the screws one by one.
Página 11
ATTENTION -Please note the direction of the holes . Leading The holes upward...
Página 12
ATTENTION -Please note the direction of the holes .
Página 13
ATTENTION -Please note the direction of the holes . Leading The holes upward...
Página 14
ATTENTION -Please note that the side with 35mm distance from the screw hole to the edge of the board 8 board should be on the front side, and the side with 25mm distance from the screw hole to the edge should be on the back side, otherwise it will affect the appearance.
Página 18
ATTENTION -This product is equipped with two types of the expansion screws, please use the correct accessories according to the wall constructions. For solid or concrete walls. For Hollow Wall.