DeWalt DXCM024-0434 Manual De Instrucciones página 6

AIR LINE INLET
The air line inlet (H) is 1/4" NPT
and is located on the on the
side of the hose reel .
MOUNTING BRACKET
The poly mounting bracket (F)
has a hose reel mounting pin (J)
that is removable so it can be
easily mounted on a wall.
LEAD-IN AIR HOSE
The lead-in hose (I) is
3/8" x 4' long and has
a swivel connection on
one end to prevent the
hose from twisting or
kinking. This comes attached to the hose reel.
AIR LINE OUTLET
The air line outlet (A) is 1/4" NPT and is located on the end of the
air hose (G) for convienient
connection to air accessories
or tools.
AIR HOSE
The air hose (G) is 3/8" x 50'
and is attached to the hose reel.
BALL STOP
The ball stop (C) is adjustable
and allows the desired length
of hose to be permanently
stored outside the hose real.
F
H
J
I
C
G
B
A
HOSE BEND RESTRICTOR
The hose restrictor (B) reduces bending stress near the fitting,
preventing damage and extending the life of the air hose (G).
INSTALLATION
1. Choose a mounting location
that is free of electrical wiring
or other obstructions and is
sturdy enough to support the
weight of the hose reel and
hose as well as the force used
to extend and retract it. The
hose reel is to be mounted on
a wall. (see Figure 2).
2. Use the included mounting template to mark and drill the hole
locations.
3 Mount the hose reel bracket in the desired location. Purchase the
appropriate fasteners at your local hardware store.
4. Slide the hose reel mounting pin (J) into the bracket (F).
5. If an adjustment needs to
be made to increase or
decrease the length of hose
that is outside of the hose
reel, pull out the hose slowly
until it latches at the desired
length. Use a Phillips head
screwdriver to loosen (2) two
screws holding the ball stop to
the hose. Adjust and then tighten the ball stop screws back snug.
(see Figure 3).
6
Figure 2
F
J
Figure 3