Orbegozo PWO 0845 Manual De Instrucciones página 11

PWO 0845 – PWO 0850
WALL
1. Loosen the screw on the fan bracket (8), separate the fan neck and connection, take out the plastic gear.
2. Turn the plastic gear 45 degrees clockwise.
3. Put the plastic gear on the fan neck, assemble the connection with the fan bracket screw and nut.
4. The installation of the base frame, fan grill and fan blades is the same as that of the floor fan.
5. Mount the hangers on the wall with screws, then hang the fan on the hangers and make sure the wall
bracket is secure.
OPERATING INSTRUCTIONS
1. Make sure the switch is in the off position, then plug in the fan
2. Speed is adjusted by moving the speed switch to the desired setting. The numbers 0,1,2,3 on the
dashboard indicate off, slow, moderate and fast respectively.
3. To oscillate the fan, pull the motor oscillating rod. The fan head will rotate from side to side.
4. The tilt angle of the wall fan is adjusted by loosening the screw on the fan neck. Adjust the angle to the
desired position and retighten the screws.
CARE, CLEANING & STORAGE
• Blades and grates should be cleaned regularly for best performance. Unplug fan and reverse assembly
instructions to remove blades and louvers before cleaning. Wipe clean with a damp cloth and dry with a dry
towel.
• Never immerse any part in water. Just wipe the fan with a damp cloth, then dry it immediately with a dry
towel.
• Always store your fan in a cool, dry place.
1. Engine
2. Connection
3. Plastic part
4. Connecting piece screw and nut
5. Bracket connection piece
11