Descargar Imprimir esta página

Craftsman 917.389390 Manual Del Usuario página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

dangerous,
if you think the engine-governed
high speed needs adjusting, contact your
nearest authorized service center, which has
proper equipment
and experience
to make
any necessary
adjustments.
ENGINE SPEED
Your engine speed has been factory seL Do
not attempt to increase engine speed or it
may result in personal injury, If you believe
that the engine is running too fast or too slow,
take your lawn mower to an authorized
service center for repair and adjustment.
TO ASSEMBLE
GRASS
CATCHER
• Put grass catcher
frame
into grass bag
with rigid part of bag on the bottom°
Make sure the frame
handle
is outside
of the bag top,
. Slip vinyl bindings
over frame.
NOTE:
If vinyl bindings
are too stiff, hold
them in warm water for a few minutes°
If
bag gets wet, let it dry before
using.
dl31bCAUT1ON: Do not run your lawn
mower without clipping deflector or
approved grass catcher in place. Never
attempt to operate the lawn mower with
the rear door removed or propped open.
Catcher
frame
handle
Frame
opening
Immediately prepare your lawn mower for
storage at the end of the season or if the unit
will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a pedod
of time, clean it thoroughly, remove all dirt,
grease, leaves, etc. Store in a clean, dry area.
Clean entire lawn mower (See "CLEAN-
ING" in the Maintenance section of this
manual).
• Lubricate as shown in the Maintenance
section of this manual.
• Be sure thatall nuts, bolts, screws, and pins
are secure_yfastened. Inspect moving
parts for damage, breakage and wear.
Replace if necessary.
• Touch up all rusted or chipped paint
surfaces; sand light, before painting.
HANDLE
• You can fold your lawn mower handle
for storage.
• Loosen the two (2) handle knobs on
sides of the upper handle and allow
handle to fold down to the rear.
• Squeeze the bottom ends of lower
handle toward each other until pins in
handle clear the brackets and pivot
entire handle assembly forward and
allow it to rest on mower.
• When setting up your handle from the
storage position, the lower handle witt
require manually locking into the
mowing position.
IMPORTANT:
When folding the handle for
storage or transportation,
be sure to fold
the handle as shown or you may damage
the control cables.
Med..
Low
pin
3-position
Handle
adjustment
bracket
Operator
Presence
Control Bar
"_.._
Upper
Handle _//
Fold Forward
_,\/._
For Storage ;r.-_-,_=;_ -=_-',':!
Lower
Handle
,:_';_
+_Fold
;y;,_
Backward
Mowing
Position
14

Publicidad

loading