Xiaomi POCO M5s Guia De Inicio Rapido página 38

EN
EU Regulations
RED Declaration of Conformity
Xiaomi Communications Co., Ltd. hereby declares that this GSM / GPRS / EDGE / UMTS /
LTE Digital Mobile Phone with Bluetooth and Wi-Fi 2207117BPG is in compliance with the
essential requirements and other relevant provisions of the RE Directive 2014/53/EU. The
full text of the EU declaration of conformity is available at the following internet address:
www.mi.com/en/certification
RF Exposure Information (SAR)
This device is in compliance with Specific Absorption Rate (SAR) limits for general
population/uncontrolled exposure (Localized 10-gram SAR for head and trunk, limit: 2.0W/
kg) specified in Council Recommendation 1999/519/EC, ICNIRP Guidelines, and RED
(Directive 2014/53/EU).
During SAR testing, this device was set to transmit at its highest certified power level in
all tested frequency bands and placed in positions that simulate RF exposure during use
against the head with no separation and near the body with a separation of 5 mm.
SAR compliance for body operation is based on a separation distance of 5 mm between the
unit and the human body. This device should be carried at least 5 mm away from the body to
ensure RF exposure level is compliant or lower than the reported level. When attaching the
device near the body, a belt clip or holster should be used which does not contain metallic
components and allows a separation of at least 5 mm to be maintained between the device
and the body. RF exposure compliance was not tested or certified with any accessory
containing metal worn on the body, and use of such an accessory should be avoided.
Certification Information (Highest SAR)
SAR 10 g limit: 2.0 W/Kg,
SAR Value: Head: 0.597 W/Kg, Body: 0.870 W/Kg (5 mm distance).
Frequency Bands and Power
This mobile phone offers the following frequency bands in EU areas only and maximum
radio-frequency power:
GSM 900: 35.5 dBm
GSM 1800: 32.5 dBm
WCDMA band 1/8: 25.7 dBm
LTE band 1/3/7/8/20/28/38/40/41 (2535-2655MHz) : 25.7 dBm
Bluetooth: 20 dBm
Wi-Fi 2.4 GHz band: 20 dBm
Wi-Fi 5 GHz: 5150 to 5250MHz: 23 dBm, 5250 to 5350 MHz: 23 dBm, 5470 to 5725 MHz: 23
dBm, 5725 to 5850 MHz: 14 dBm
NFC: 13.56 MHz < 42 dBuA/m at 10m
FCC Regulations
This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information (SAR)
This device meets the government's requirements for exposure to radio waves. This
device is designed and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy. The exposure standard for wireless devices employs a unit of
measurement known as Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/Kg. For body-worn operation, this device has been
tested and meets the FCC RF exposure guidelines for use with an accessory that contains
no metal and positions the device a minimum of
1.5 cm from the body. RF exposure compliance with any body-worn accessory that contains
metal was not tested and certified, and use of such body-worn accessory should be
avoided. Any accessory used with this device for body-worn operation must keep the device
a minimum of 1.5 cm away from the body.
FCC Note
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
01