Publicidad
Idiomas disponibles
Idiomas disponibles
ENG
Distance configuration: the default is two kilometers, it should be set according to your needs. (The
same distance value must be set in the transmitter and receiver. Otherwise, a low-latency, low-ban-
dwidth network connection will occur.)
4. QUESTIONS & ANSWERS
Q1: What should be noted when setting the AP DIP switches?
A1: Make sure the power is off
Q2: How does the AP work without a dedicated power supply?
A2: The AP receives power through the cat5e cable. Called PoE. Two cables are required for con-
nection. It is recommended to use STP Cat5e cables.
Q3: How long can the PoE cable be?
A3: The length of the cable depends on the supply voltage and the quality of the cable. For 24 V
power supply, the cable length can typically be 100 meters and up to 200 meters for 48 V power
supply.
Q4: Why don't I see any signal lights when the AP should be on?
A4: We recommend that you run a troubleshooting test as described below. For the transmitter, set
all buttons "1" to "10" UP. For the receiver, set buttons "1" DOWN and buttons 2 to 10 UP. At the end
turn on the device and wait 3 minutes. The distance between the transmitter and the receiver must
be more than 2 meters. If you still see no indication that the units are on and communicating with
each other, contact your dealer.
Transmitter
Receiver
Q5: Why is the local network connection unstable after installation?
A5: We suggest you try two actions:
1. Change the cable to see if it is cable problem
2. Try changing the wireless channel (different DIP switch settings between buttons 2 and 8) to elimi-
nate interference. If you are still having problems contact your dealer.
Q6: Is the 10-digit AP compatible with the previous 8-digit ones?
A6: Yes. Enter the WEP page, as per instructions, select the "system" menu, click on "mode", check
the "8-digit DIP switch mode" box, then "Save changes". Turn off the AP, configure it according to the
instructions for an 8-digit DIP device. (Focusing on buttons 1 to 8 only).
Q7: I have an 8-digit switch. Is it compatible with the new 10-digit devices?
A7: Yes. Enter the WEP page, as per instructions, select the "system" menu, click on "mode", check
the "8-digit DIP switch mode" box, then "Save changes". Turn off the AP, configure it according to the
instructions for an 8-digit DIP device. (Focusing on buttons 1 to 8 only).
7
Publicidad
