Publicidad
Idiomas disponibles
Idiomas disponibles
Programming the
Remote Control for a
Home Entertainment
Device
Your HP remote control is programmable. Program the
remote control to operate other home entertainment
devices such as your audio receiver, DVD player, PVR,
or set-top box. Manufacturer codes for compatible
brands are listed at the end of this section.
You can also program a second device such as an
external sound system for volume mapping, where
pressing the Volume buttons or Mute button sends an IR
remote code to adjust the sound level at the second
device.
n
If the brand of your device is not listed in
"Manufacturer's codes" on page 53, try
programming the device code by using the
steps in "Programming the device code by
using auto setup mode" on page 52.
50
HP MediaSmart HDTV User Guide
Programming the device code
Use these steps to program a device button if your
brand is listed.
Read all the steps completely before
proceeding. Before performing step 4,
highlight or write down the codes and
device you want to program. If your
manufacturer is not listed in
"Manufacturer's codes" on page 53, try
programming the device code by using the
steps in "Programming the device code by
using auto setup mode" on page 52.
1
2
3
4
5
Get other manuals https://www.bkmanuals.com
n
Locate the brand of your device and the
manufacturer's codes (see the listings in
"Manufacturer's codes" on page 53).
Turn on the TV. Turn on the device you want to
program.
Press the Device button on the remote control as
needed to select the device to program (CBL,
DVD, AVR, or AUX). Wait until the device
indicator light on the remote control goes out.
Press and hold down the Device button on the
remote control for 5 seconds, until the device
indicator light blinks, and then release the Device
button. The device light blinks one more time and
then remains lit, indicating the remote control is in
programming mode.
Enter the first four-digit code for your manufacturer
from the table. If the code is accepted, the device
light blinks twice. If the code is not accepted, the
device light blinks three times.
Publicidad
