cRadia CRA 3020 Manual De Usuario página 18

Product Inspection
Unpacking the box and open the outer carton and remove the accessories packed in the box.
●
● Carefully lift the cabinet out of the outer carton. Note the UPS mode with internal battery is heavy, two
person or proper tools should be used to take the equipment out. Inspection equipment.
Check the product appearance, display, terminal block, socket, connector, NO contamination and
●
deformation should be found.
Checking accessories according to below of shipping list.
●
Please contact the distributor if damages or lack of accessories are found.
●
Installation
Install the UPS in a protected area where is free of excessive dust and has
adequate air flow. Please place the UPS away from other units at least 20 cm
to avoid interference. Do NOT operate the UPS where the temperature and
humidity is out of the specific limits. (Please check the specs for the
limitations.)
Connect to Utility and Charging
Plug in the AC input power cord to the wall outlet. For the best
results, it is suggested to charge the battery for at least 6 hours
before initial use. The UPS charges its battery while connecting to
the utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the power switch of UPS unit,
then devices connected to the UPS are protected.
Connect USB cable (Optional)
Connect the USB cable to UPS and Computer, insert CD to computer and follow the wizard to install the
monitoring software properly.
Connect Modem/Phone for Surge Protection
Connect a single modem/phone line into surge-protected "IN" outlet on the back panel of the UPS unit. Connect
from "OUT" outlet to the computer/Modem with phone line cable.
Turn On/O the Unit
Turn on the UPS unit by pressing the On/Off switch. Turn off the UPS unit by pressing again the On/Off switch.
INSTALLATION
EN
18