Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Malfunctions
Switch off the log splitter and pull out the mains power plug in the event of malfunctions occu rring. Engage a specialist firm or
workshop to remedy malfunctions that cannot be rectified on the basis of the following table.
Malfunction
The log pusher does not move
out/in
The log pusher does not exert
any force
Hydraulic
pump
makes
whistling noise, the log pusher
moves with a jerking motion
Motor becomes excessively hot
Motor is not starting
Environmental protection, disposal
Do not dispose of old units in household waste!
The packaging, unit and accessories are made of materials that can be recycled and should be disposed of
in a suitable manner.
GB 5
Cause
Too little hydraulic oil
Hydraulic pump is defective
The splitter is inclined towards the splitting
wedge
Too little hydraulic oil
The splitter is inclined towards the splitting
wedge
a
Too little hydraulic oil
The splitter is inclined towards the splitting
wedge
Air inside the circulation system
Cable cross section is too small
Thermostatic switch has switched off
Mains plug or socket is defective
Cable is defective
Electric motor is defective
Remedy
Top up hydraulic oil
Replace hydraulic pump
Position the splitter on a horizontal plane or
inclined towards the operating lever
Top up hydraulic oil
Position the splitter on a horizontal plane or
inclined towards the operating lever
Top up hydraulic oil
Position the splitter on a horizontal plane or
inclined towards the operating lever
Open the venting screw
Use cable with larger cross section
Wait until the motor has cooled down
Let an electrician check the plug
Replace by an electrician
Let an electrician check the motor
Translation of original user instructions
Log splitter
Publicidad
